This New lead was released for 2005 onwards Kia and Hyundai cars which have an Amp under the drivers seat with HYUNDAI written on it and that have the plug type as shown in the picture.
The 06-015 relay module fitted to this lead steps down the speaker volume to that required by the amplified system. Although the lead is usually pre set to a reasonable level, you can adjust the audio output using the thumb wheel on the relay. Setting up and testing of audio is advised before putting the radio and trim back together .
If you require further information on this product either post on our forum or you can contact the Autoleads technical department via their Website at www.autoleads.co.uk.
This lead will suit the following vehicles:
Cellular Telemute leads are used when installing an aftermarket hands free car phone kit. Once installed the lead will mute your head unit and redirect the call through the vehicles front speakers. This Autoleads Telemute lead is now terminated with the NEW Nokia 4 pin Molex power plug as used by the CK-7W. If using another make of handsfree car kit you will require an Adaptor Lead for converting the Autoleads Telemute lead without chopping the wires and invalidating it's warranty. These leads supply your hands free car kit with power as well so you that you do not have to run cables directly to your cars battery.
Advantages include:
The 06-902B Telemute lead from Autoleads Is a Vehicle Specific type lead . You will get crystal clear audio reproduction through the vehicles own front two speakers.
This lead is suitable for 12 volt negative earth systems only!
All Autoleads products should be Installed by a suitably qualified technician. We will not be held responsible for damage to the vehicles electrical system due to incorrect installation or misuse of the product.
We will however provide FREE technical support via e-mail, or our Technical support forum. You would be expected to have a good understanding of vehicle electric's and a suitable 12 volt test lamp probe available for testing and configuration purposes.