When you wish to put your handsfree car phone kit through your stereo and make it mute during a call, and redirect the audio through the cars audio system, you will require an Autoleads Cellular Telemute Interface lead.
These are available from our Autoleads Cellular Telemute lead section of the online shop.
All Autoleads Cellular Telemute leads up until 2005 were made to the Nokia standard 6 pin Molex plug configuration as used in car kits like the Nokia CARK-91. Some newer leads will have the new Nokia 2002> 4 pin Molex connector, which means if you wish to install any other make of kit apart from Nokia, or an older Nokia kit such as the CARK-91, then you will require this 06-221B adaptor.
In order to use an older Nokia handsfree car phone kit or any other manufacturers kit with any Autoleads Cellular Telemute Interface lead with the new four pin Molex type connector fitted, you will require the adaptor listed above as well as the relevant adaptor for your kit. This simply plugs into the Nokia 4 pin Molex power plug on the fly lead of the Telemute and saves you chopping any wires keeping the warranty of the lead intact. This is because Nokia have changed the standard 6 pin Molex power plug to a 4 pin Molex power plug on their later car kits and Autoleads are phasing in newer leads to suit the newer Nokia kits.
All Autoleads products should be Installed by a suitably qualified technician. We will not be held responsible for damage to the vehicles electrical system due to incorrect installation or misuse of the product.
If you require further information on this product either post on our forum or you can contact the Autoleads technical department via their Website at www.autoleads.co.uk .
You would be expected to have a good understanding of vehicle electric's and a suitable 12 volt test lamp probe available for testing and configuration purposes when installing this product.