This lead is already configured to use the radio mute feature during a call. The difference between this lead and the earlier 06-053B lead is that the top plug now has a 20 way Mini ISO type connector rather than the earlier larger pinned 10 way ISO and it does not have a V3 module. This lead can be used instead of the 06-078B lead on some cars. Allows volume control via steering wheel remote buttons but it requires the ignition on in order to function unlike the 06-078B. If you have the pre wired 18 pin VDA telephone loom as fitted to a lot of Vauxhall cars you will require the 06-102B. Sat Nav and Bose head units will require an 06-212B electronic filter fitted to the audio input wires of the Telemute lead to save distortion of audio.
This lead must not be used with any Motorola car kit! This is due to different Impedance ratings (Ohms) on the speaker output of the Motorola kit and the Vauxhall head unit and can cause the Motorola control unit to Blow!
Some cars that require a heavy amperage on the ignition sense wire such as Ericsson, may require you to source this feed elsewhere. This is because the ignition sense on the back of the head unit is only a low amperage and is a trigger wire only. This is fine with Nokia and bluetooth car kits that only require a low amperage trigger wire output but will cause the radio to power off with kits with a high current draw!
If you require further information on this product either post on our forum or you can contact the Autoleads technical department via their Website at www.autoleads.co.uk.
The Vauxhall 06-115B 36 way lead is designed to fit Vauxhall cars with the Standard Factory fitted head unit installed. This lead takes over from the 26 way 06-053B used in pre 2002 cars. 02> Vectra and 02> Omega cars can also use the 06-078B lead.
Not Suitable for Motorola car kits! As it can cause the control unit to Blow! You must Use the 06-078B or 06-102B leads instead!
This lead will suit the following vehicles:
N.B. If you have Bose or Sat Nav, an 06-212B Electronic Filter will have to be hardwired into the audio input wires from the car kit!
Cellular Telemute leads are used when installing an aftermarket hands free car phone kit. Once installed the lead will mute your head unit and redirect the call through the vehicles front speakers. All of the Autoleads Telemute leads are terminated with the standard Nokia 6 pin Molex power plug. If using another make of handsfree car kit you will require an Adaptor Lead for converting the Autoleads Telemute lead without chopping the wires and invalidating it's warranty. These leads supply your hands free car kit with power as well so you that you do not have to run cables directly to your cars battery.
Advantages include:
The 06-115B Telemute lead from Autoleads Is a Vehicle specific connector type lead that does not require any configuration. It will display "PHONE" or "MESSAGE" on the vehicle's HUD during a telephone call. You will get crystal clear audio reproduction through the vehicles own front two speakers.
This lead is suitable for 12 volt negative earth systems only!
All Autoleads products should be Installed by a suitably qualified technician. We will not be held responsible for damage to the vehicles electrical system due to incorrect installation or misuse of the product.
We will however provide FREE technical support via e-mail, or our Technical support forum. You would be expected to have a good understanding of vehicle electric's and a suitable 12 volt test lamp probe available for testing and configuration purposes.