To use this lead you will have to remove the centre armrest and cubby hole units from the centre console. After locating the 10 way plug it is a good idea to test for a phone mute on the plug as they all look the same, if you find the plug has a pin which mutes the stereo when an earth is applied to it, you are in luck. This lead also comes with an additional mic adaptor (lead with blue plug), this saves running the mic cable if you can find the plug up in the centre light, you will have to connect the kits mic to this jack socket but it does save running cables or you can leave it out and run the mic as normal, not all cars will use this. This lead has a female socket with 10 male pins and is designed for cars with a male plug with 10 female recepticles, if your car has a female socket with male pins then you will require the 06-101B-SPECIAL instead.
If you require further information on this product either post on our forum or you can contact the Autoleads technical department via their Website at www.autoleads.co.uk.
This lead will suit the following vehicles:
Not Suitable for Amplified Systems!
Cellular Telemute leads are used when installing an aftermarket hands free car phone kit. Once installed the lead will mute your head unit and redirect the call through the vehicles front speakers. All of the Autoleads Telemute leads are terminated with the standard Nokia 6 pin Molex power plug. If using another make of handsfree car kit you will require an Adaptor Lead for converting the Autoleads Telemute lead without chopping the wires and invalidating it's warranty. These leads supply your hands free car kit with power as well so you that you do not have to run cables directly to your cars battery.
Advantages include:
The 06-101B Interface lead from Autoleads Is a Vehicle specific connector type lead that Automatically mutes the radio on a call. You will get crystal clear audio reproduction through the vehicles own front two speakers.
This lead is suitable for 12 volt negative earth systems only!
All Autoleads products should be Installed by a suitably qualified technician. We will not be held responsible for damage to the vehicles electrical system due to incorrect installation or misuse of the product.
We will however provide FREE technical support via e-mail, or our Technical support forum. You would be expected to have a good understanding of vehicle electric's and a suitable 12 volt test lamp probe available for testing and configuration purposes.