This lead is virtually "Plug and Play" with Mercedes cars that use the newer Flat pin 'Quadlok' type connector plug and have the AUDIO 10 sound system. You will have to connect the pink mute wire on the lead into the corresponding bullet connector on the Autolead after testing the head unit to see which wire is the mute.
There is a separate blue fly wire that needs to be connected to a separate ignition switched live feed which means that the lead is not 100% "Plug and Play" and some knowledge of vehicle wiring is required to obtain the correct ignition supply. Bluetooth car phone kits require this ignition feed to tell the kit to switch on and look for your phone.
Typical Ignition feed pick up points -
WARNING! - When sourcing your separate ignition feed, use wire with at least a 5 amp load capacity, Always solder or use approved insulated Crimp type connectors (Skotch loks are NOT advised!) when splicing in, and fuse with a 2-3 amp fuse as close as possible to the take of point in case of short circuit.
If you require further information on this product either post on our forum or you can contact the Autoleads technical department via their Website at www.autoleads.co.uk.
This lead will suit the following vehicles:
Cellular Telemute leads are used when installing an aftermarket hands free car phone kit. Once installed the lead will mute your head unit and redirect the call through the vehicles front speakers. This Autoleads Telemute lead is now terminated with the NEW Nokia 4 pin Molex power plug as used by the CK-7W. If using another make of handsfree car kit you will require an Adaptor Lead for converting the Autoleads Telemute lead without chopping the wires and invalidating it's warranty. These leads supply your hands free car kit with power as well so you that you do not have to run cables directly to your cars battery.
Advantages include:
The 06-097B Telemute lead from Autoleads Is a Vehicle Specific type lead that does require a separate ignition switched live feed to be run. "PHONE" is displayed during a call on most vehicles. You will get crystal clear audio reproduction through the vehicles front two speakers.
This lead is suitable for 12 volt negative earth systems only!
All Autoleads products should be Installed by a suitably qualified technician. We will not be held responsible for damage to the vehicles electrical system due to incorrect installation or misuse of the product.
We will however provide FREE technical support via e-mail, or our Technical support forum. You would be expected to have a good understanding of vehicle electric's and a suitable 12 volt test lamp probe available for testing and configuration purposes.