The Autoleads 06-096B Nissan Cellular Telemute Interface lead for 2004 onwards cars



06-096B additional Technical Information

The 06-096B Nissan Cellular Telemute Interface lead is a vehicle specific lead that is designed to fit the majority of Nissan cars manufactured After 2004 that have two plugs instead of the one large one on the 06-075B.

This lead will suit the following vehicles:

 

This is based on the car still being fitted with the original Nissan head unit, cars fitted with aftermarket stereos will most likely need the 06-050B.

This lead is not suitable for the 2004 X-Trail with Sat Nav system use the 06-096NB instead.


Cellular Telemute leads are used when installing an aftermarket hands free car phone kit. Once installed the lead will mute your head unit and redirect the call through the vehicles front speakers. All of the Autoleads Telemute leads are terminated with the standard Nokia 6 pin Molex power plug. If using another make of handsfree car kit you will require an Adaptor Lead for converting the Autoleads Telemute lead without chopping the wires and invalidating it's warranty. These leads supply your hands free car kit with power as well so you that you do not have to run cables directly to your cars battery.

Advantages include:

The 06-096B Cellular Interface lead from Autoleads Is a Nissan Only type lead . You will get crystal clear audio reproduction through the vehicles own front two speakers .

This lead is suitable for 12 volt negative earth systems only!


All Autoleads products should be Installed by a suitably qualified technician. We will not be held responsible for damage to the vehicles electrical system due to incorrect installation or misuse of the product.

We will however provide FREE technical support via e-mail, or our Technical support forum. You would be expected to have a good understanding of vehicle electric's and a suitable 12 volt test lamp probe available for testing and configuration purposes.

06-096B Product Specification and Technical Information

Pictured above is the mute wire on the 2004> Nissan X-Trail. The pink mute wire that comes out the V3 module on the head unit end of the lead needs to be connected to the white wire with banding as shown above. Please do check that this is the correct mute position for your vehicle, this is only an image of the one we found recently on a 54 plate X-Trail.

If you require further information on this product either post on our forum or you can contact the Autoleads technical department via their Website at www.autoleads.co.uk.

This lead is a direct radio interface loom and radio removal and radio code will be required. This lead is used on 2004> Nissan cars with two Audio plugs, one with 12 pins and the other has 8 pins. Earlier models with a large white single connector plug will require the 06-075B. We do not have information as yet on all the radio mute positions.