This lead is designed to work with the 5000, 6000 and 6006E series of head units from Ford. We will add one yellow wire to the lead which you will need to insert in the position shown here and cable tie it to the white/green wire to secure it. Some later models have the power and speaker plugs mounted horizontally but the idea is the same. Some base models do not have the mute plug, this lead can also be configured to turn the stereo off during a call when the mute is not available by changing one bullet connector over on the lead.
If you require further information on this product either post on our forum or you can contact the Autoleads technical department via their Website at www.autoleads.co.uk.
This lead will suit the following vehicles:
Not suitable for Amplified Systems!
Cellular Telemute leads are used when installing an aftermarket hands free car phone kit. Once installed the lead will mute your head unit and redirect the call through the vehicles front speakers. This Autoleads Telemute lead is now terminated with the NEW Nokia 4 pin Molex power plug as used by the CK-7W. If using another make of handsfree car kit you will require an Adaptor Lead for converting the Autoleads Telemute lead without chopping the wires and invalidating it's warranty. These leads supply your hands free car kit with power as well so you that you do not have to run cables directly to your cars battery.
Advantages include:
The 06-074B Telemute lead from Autoleads Is a Vehicle Specific type lead that does not require any configuration apart from one mute wire. "PHONE" is displayed on the stereo during a call. You will get crystal clear audio reproduction through the vehicles own front two speakers.
This lead is suitable for 12 volt negative earth systems only!
All Autoleads products should be Installed by a suitably qualified technician. We will not be held responsible for damage to the vehicles electrical system due to incorrect installation or misuse of the product.
We will however provide FREE technical support via e-mail, or our Technical support forum. You would be expected to have a good understanding of vehicle electric's and a suitable 12 volt test lamp probe available for testing and configuration purposes.
