The Autoleads 06-068B Chrysler up to 2002 Cellular Telemute Interface lead



The Autoleads 06-068B Chrysler Cellular Telemute Interface lead

06-068B additional Technical Information

The Chrysler Telemute Interface lead is designed only to fit the vehicles listed below fitted with the plug connector as shown in the picture above. This lead is suitable for most Infinity systems that use line level feeds.

This lead will suit the following vehicles:


Cellular Telemute leads are used when installing an aftermarket hands free car phone kit. Once installed the lead will mute your head unit and redirect the call through the vehicles front speakers. All of the Autoleads Telemute leads are terminated with the standard Nokia 6 pin Molex power plug. If using another make of handsfree car kit you will require an Adaptor Lead for converting the Autoleads Telemute lead without chopping the wires and invalidating it's warranty. These leads supply your hands free car kit with power as well so you that you do not have to run cables directly to your cars battery.

Advantages include:

The 06-068B Cellular Interface lead from Autoleads Is a Chrysler Only type lead . You will get crystal clear audio reproduction through the vehicles own front two speakers.

This lead is suitable for 12 volt negative earth systems only!


All Autoleads products should be Installed by a suitably qualified technician. We will not be held responsible for damage to the vehicles electrical system due to incorrect installation or misuse of the product.

We will however provide FREE technical support via e-mail, or our Technical support forum. You would be expected to have a good understanding of vehicle electric's and a suitable 12 volt test lamp probe available for testing and configuration purposes.

06-068B Product Specification and Technical Information

This lead can be used with some of the Infinity amplified systems (Such as the Gold system) fitted to Chrysler vehicles that use full line level signal to the amp, not suitable for infinity that uses pre-amp level signals. On some vehicles you may have to fit a diode inline on the mute wire if the front speakers do not come back on after a call, this is due to some voltage differences in the head units and is not always required.

If you require further information on this product either post on our forum or you can contact the Autoleads technical department via their Website at www.autoleads.co.uk.