The Autoleads 06-047B Honda 2000> with Premium Sound Cellular Telemute Interface lead



The Autoleads 06-047B Honda 2000> with Premium Sound Cellular Telemute Interface lead
The picture above shows the AMP location that the lead needs to be plugged into. it is accessed after removing the surrounding trim. The amp is located below the DVD unit.
The Honda Premium Sound lead is designed to fit Honda cars manufactured after 2000 with 20 way plugs which do have Amplified Premium Sound head units and are fitted with the Factory standard or Sat Nav stereo's.

This lead will suit the following vehicles:


Cellular Telemute leads are used when installing an aftermarket hands free car phone kit. Once installed the lead will mute your head unit and redirect the call through the vehicles front speakers. All of the Autoleads Telemute leads are terminated with the standard Nokia 6 pin Molex power plug. If using another make of handsfree car kit you will require an Adaptor Lead for converting the Autoleads Telemute lead without chopping the wires and invalidating it's warranty. These leads supply your hands free car kit with power as well so you that you do not have to run cables directly to your cars battery.

Advantages include:

The 06-047B Telemute lead from Autoleads Is a Vehicle specific connector type lead which will mute the stereo on a phone call. You will get crystal clear audio reproduction through the vehicles own front two speakers.

This lead is suitable for 12 volt negative earth systems only!


All Autoleads products should be Installed by a suitably qualified technician. We will not be held responsible for damage to the vehicles electrical system due to incorrect installation or misuse of the product.

We will however provide FREE technical support via e-mail, or our Technical support forum. You would be expected to have a good understanding of vehicle electric's and a suitable 12 volt test lamp probe available for testing and configuration purposes.

06-047B Product Specification and Technical Information

AMP location that the lead needs to be plugged into

06-047B additional Technical Information

Please note that this lead interfaces directly with the amplifier unit and NOT the head unit itself! Remove the amp located behind the ashtray unit, Plug the harness in between the 20 way amp input sockets. The mute wire, which works on a positive trigger, and is controlled by the additional 06-016 relay, must be connected manually to the 20 way plug on the back of the stereo, please ensure that the 1 amp fuse is installed on this wire and under no circumstances, connect the mute wire from the kit directly to this wire!.

Mute pin Information on the actual head unit is as shown in the diagram below.

If you require further information on this product either post on our forum or you can contact the Autoleads technical department via their Website at www.autoleads.co.uk.
To Purchase this item see - www.siocommunications.co.uk/Shopping/view_product.php?product=06-047B